Laboratory measurement of the interface pressures applied by active therapy support surfaces: A consensus document☆
published online 25 January 2010.
Abstract
A key element in pressure ulcer prevention and management is the selection of appropriate pressure redistributing (PR) patient support surfaces for use while seated and in bed. However little explicit guidance exists allowing standardised quantitative comparison of different PR surfaces based upon their ability to redistribute pressure from anatomical landmarks such as the heels and sacrum. In 2008 a working group was established in Europe through the US National Pressure Ulcer Advisory Panel (NPUAP) support surface standardisation initiative (S3I) and under the aegis of the European Pressure Ulcer Advisory Panel with the specific remit of developing test methods for the evaluation of active therapy support surfaces (alternating pressure air mattresses). This report describes a consensus development process to agree test methods appropriate to compare active therapy surfaces based upon their ability to redistribute pressure from the sacrum and the heels.
☆ This document sets out a consensus statement upon the evaluation of active therapy support surfaces in the laboratory. The Journal of Tissue Viability is pleased to publish this draft statement, which has not been subjected to the peer review process used by this Journal. The statement is intended to create debate and comments are welcome through tissue.viability@btinternet.com until the 31st March 2010.
This consensus statement was developed and commented upon by a wide multi-disciplinary team including Dan Bader, Michael Clark, Carol Dealey, Shyam Rithalia (UK), Cees Oomens, Richard Goossens (the Netherlands), Per Ask, Margareta Lindgren (Sweden), Makamoto Takahashi (Japan).
ABSTRACT